About The Steps to Replace Airwheel S6 Mini Self-Balancing Scooter's Control Panel and Transformer Board

  • Source:Airwheel

Abstract: The most outstanding feature of Airwheel S6 two wheel electric walkcar is the dual riding modes. When in sitting posture, people are more likely to feel safe with a low centre of gravity. It is easier to make their body relaxed and easier to learn. When they have practiced sitting to ride expertly, they can try to stand to ride. Such flexible ability to alter ride modes owns to its quality control panel and transformer board.

 

Airwheel S6 electric walkcar does well in providing riders' satisfactory experience, as riders can ride in two very different configurations, depending on how they feel most comfortable: either sit on the ergonomic saddle or stand on the platform by pressing the seat with legs to go forward and backword. This is mainly because of the control panel and transformer board. Do you know how to change them?

 

To replace the control panel and transformer board, you need to remove the cushion, remove the supporting rod of the saddle and remove the upper cover screw.

Airwheel S6 electric self-balancing scooter


Then, remove the cover and disconnect the power cord, remove the control board. Record the wiring position in the control board, and then remove the control board.

self balancing electric scooter

 

The next step is to remove the transformer board. Before removing the transformer board, record the wiring position. Replace the transformer board and fix the transformer board and connect wires as recorded. Organize wires.

self-balancing electric scooter

 

Then, you need to replace the control panel and fix control board. Refer to the previous record, arrange and fix the wirings. Connect the power cord. After replacing the new control board, the vehicle needs to be calibrated. Turn on the power, short connect the J3 interface as shown in the figure.

mini electric scooter

 

Shorten the J3 interface and e press the remote control A key to start. A few seconds later, disconnect it and wait for calibration to complete

self-balancing scooter


Lastly, you need to install the upper cover, install the supporting rod of the saddle and install the saddle to finish the operation.

S6 electric walkcar


If the words make you feel boring, you can visit the https://www.youtube.com/watch?v=ZkrmPErbpQs to have a more vivid description of Airwheel S6 sitting-posture electric scooter.

Next:The Malaysian Distributor Of Airwheel Airwheel self-balance electric unicycles A Rugby Match
Airwheel facebook